I appreciate the efforts of the development team.
In my environment, when the solver is run three times since yesterday's update, the symptoms of the mount are considerably out of the actual position.
My mount is using the SynscanAltAZ driver. There was a problem with alignment with this alignment module. (The DSC driver has not been solved yet)
He repeated the solver to get the correct position.
However, if you run the solver from the previous day's update yesterday, you will notice that the synchronization point is far from the actual mounting position and will not be available until all power is turned off.
The picture frame of the screenshot is the correct position of the mount.
It will be displaced like a screenshot in the third Solver & Sync, and will not show the correct position after that.
Please tell me the solution.
We will send logs and screenshots.
In my environment, when the solver is run three times since yesterday's update, the symptoms of the mount are considerably out of the actual position.
My mount is using the SynscanAltAZ driver. There was a problem with alignment with this alignment module. (The DSC driver has not been solved yet)
He repeated the solver to get the correct position.
However, if you run the solver from the previous day's update yesterday, you will notice that the synchronization point is far from the actual mounting position and will not be available until all power is turned off.
The picture frame of the screenshot is the correct position of the mount.
It will be displaced like a screenshot in the third Solver & Sync, and will not show the correct position after that.
Please tell me the solution.
We will send logs and screenshots.
