Since installing the new Ekos update 2.9.2 guiding calibration using the ST4 cable no longer works with the internal guider. Works fine with PhD2, so cable is not the culprit. Error message is that after drifting in RA reverse the mount can't reach starting point after 35 iterations. I did not change anything in the setup since the previous version, so I assume this is update related. I cycled through various calibration pulse lengths, no effect. After entering RA reverse calibration the mount rapidly drifts away from the intended target and fails to recover.
However, this problem only occurs when guiding through the ASI120MM guide port. It does not happen when I guide directly through the EQ mount (Orion Atlas Pro), however there the deviations in both axes are usually higher than when I guide through the camera directly, so it would be great to get that function back.
Has anyone else had this problem?
Thanks to the team for making this fantastic tool available to the community!
However, this problem only occurs when guiding through the ASI120MM guide port. It does not happen when I guide directly through the EQ mount (Orion Atlas Pro), however there the deviations in both axes are usually higher than when I guide through the camera directly, so it would be great to get that function back.
Has anyone else had this problem?
Thanks to the team for making this fantastic tool available to the community!