I have two equipment profiles. One for an RC6 with Moonlite focuser, and another for a 102mm APO with Moonlite focuser. Because the focusers are the same brand, I noticed that the driver under the equipment manager maintains the the same settings for either device as if it's the same device.
Where this causes me an issue is that the draw tube length on the APO is around 28,400 ticks on the stepper motor, and for the RC6 it's around 4,500. So, if I've been imaging with one and the max range is set to 4,500, then switch to the other is 28,400, I have to manually update the max range even though I'm loading a new profile. Is there any way to store the settings separately per profile?
Where this causes me an issue is that the draw tube length on the APO is around 28,400 ticks on the stepper motor, and for the RC6 it's around 4,500. So, if I've been imaging with one and the max range is set to 4,500, then switch to the other is 28,400, I have to manually update the max range even though I'm loading a new profile. Is there any way to store the settings separately per profile?